Pedestal Guard Replacement

Submitted by Bill Ahillen, Kathy II, C380 #5

I replaced the 1” pedestal guard with a Navpod 1.25 inch. It included the feet while the Edson feet are extra cost I believe. I got the AG126 which is about a 13 inch offset. I think I could have used the AG125 which is about 9 inch offset and reduced the footprint over the table. I had a C90W on the lower angled section and the instrument pod on the upper section of the pedestal guard. I also replaced the plate below the compass with the one from navpod which is stainless. At first I tried to drill the aluminum top plate but did not get a clean hole. Also by using the Navpod stainless steel top plate I will not get any galvanic action. It is isolated at the compass with gaskets. (Navpod TP125 top plate and was about $85

You need to be logged in to see the rest of this content.  Catalina380-IA members, please login.

To join please fill out a membership application (Association->Membership Application) and send a check to the address on the form.

This site uses Akismet to reduce spam. Learn how your comment data is processed.