Sink Cover
Jim Peta

5/1/2002
Hull #: 305

I would like to share this with the other owners. I saw this idea on other boats at shows and Linda really liked it. I told her I could buy a bigger boat or make one. In the C380, the sink is built with a lip all around it, so I measured and made some plans. At West Marine, I purchased a piece of acrylic (12″ x 27″) #479736, $28.99 plus tax. From this acrylic, I cut two pieces that fit on the lip of the sink, which supports these pieces. On the left piece, I cut the curves using the cutting board as template. On the right piece, I cut out a “U” shape for the fingers to fit in to lift the cutter board. In each piece I drilled a 1″ hole for a finger to lift out the acrylic.