Hello all,
My port light was not working after a long trip. I decided to replace both bow lights, port and starboard. The starboard side works fine, but the port does not. I tested with a multi-meter and it only reads 10volts. I checked under the v-berth and see only 2 wires going forward. I guess this is for both lights. Does anyone know where these wires are connnected at? There is no access to these wires without pulling the bow pulpit. Do the screws for the pulpit go only in to glass, or is there a nut beneath?

Thanks,
Russell C380 #20

Hi Russell,

I replaced my bow lights with sealed Hella Led units last year. I wanted to maintain the continuous integrity of the wire on these lights so I did pull the pulpit. My bow pulpit has machine screws that thread into an aluminum plate embedded